-12-
1. Remove the log that covers the fuel compartment door. Be very careful about where you
touch the log. See Figure 11. Make sure you handle the log on the branch that is farther from
the ames. CAUTION: THE AREAS OF THE LOG THAT ARE CLOSEST TO THE FLAME ARE
VERY HOT AND WILL BURN YOUR HAND. Set the log in a safe place where it will not be:
damaged, come into contact with anything combustible, or be touched by somebody else.
2. Open the door of the fuel canister compartment using the hole in the door. (see Figure 12).
3. Grasp the empty canister by the notches provided. Pull it up and tip it so that it clears
the bracket and then lift it straight up to remove it. Make sure the left side stays tipped
downwards to minimize any spilling that may occur if the canister still has some fuel in it.
(see Figure 13).
4. Install a new canister as described above (see INSTALLING THE FUEL CANISTER, Steps 3
and 4).
5. After the canister has been installed, close the door of the fuel compartment. Make sure you
use the hook on the side of the door to close it, because the top of the door may be hot.
Replace the log. The appliance is now ready to use.
*NOTE: Burn times will vary depending on conditions such as: wind, outside temperature, and
levelness of the appliance. Maximum burn time is achieved when the 3 rings are installed in the
burners. See Section VIII.
VIII. ADJUSTING THE FLAMES
This appliance comes with a set of three ame adjustment rings that were originally shipped inside
the burners. You can use them to reduce the size of the ames and increase the burn time, if you
like. Simply place a ring in a burner cylinder (when the unit is not burning and is cool. DO NOT
attempt to do this while the unit is burning or is still hot). The hole in the ring should be centered
over the hole in the burner cylinder, and you should not use more than one ring per cylinder. The
rings should rest horizontally inside the burners. You do not need to use any rings—this will give
you the largest ames, but the shortest burn time. You also have the option to place one or two
rings in one or two burners respectively and leave the others without rings.
IX. EMPTYING WATER FROM THE BURNERS
Before lighting the appliance, you must always be certain that there is no water in the burners.
Always cover the appliance with the supplied water proof cover when not in use. This will prevent
water and debris from entering the burners.
If you nd water, you must empty it out before using the appliance. To do so, remove the logs, log
plate, and burner. Invert the burner, and shake it vigorously until all the water has been emptied
from it. Reinstall the logs, log plate, and burner according to steps 6 to 8 in the INSTALLATION
section above.
(22 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals