-14-
4. To extinguish the ames, grasp the handle of the snuer device, and slide the cover forward
over the burner slot. The slot must be completely covered to extinguish the ames. This
appliance can be relit at any time—even immediately after extinguishing, if desired, using the
igniter.
Figure 14
Check for leaks on the floor of the fireplace under the areas indicated.
X. REFUELING
This appliance is designed so that one canister of illuma-fuel
®
(1 L) will provide a continuous
supply of fuel to the burner for about an hour and forty-ve minutes*. To allow for uninterrupted
burning beyond this time, the burner has been designed so that ten minutes before the fuel is
completely exhausted, the ame will start to shift to the right side of the burner. At this point, you
can replace the empty canister with a full one. This can be done while the appliance is burning—
there is no need to extinguish the ames.
To change the canisters:
1. Open the door on the top of the front log of the log pile. The open door acts as a ame shield.
Use your ngers to lift the top door as shown in Figure 15. Only touch in the areas indicated.
Please note that even though the area indicated in Figure 15 is cool, areas of the log closer to
the ame will be hot.
2. Check the fuel canister and make sure IT IS EMPTY.
3. Grasp the empty canister by the notches provided in the canister body (see Figure 16). Pull it
up and tip it so that it clears the bracket (make sure the left side of the canister is tipped so it is
lower than the right side) and then lift it straight up to remove it. Keep the canister away from
the ames. Keep canister tilted down on the left side while removing it. This will ensure that
any small amount of fuel that may still be in the canister does not spill out.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals